Search results

Nah, Virgin Business uses Hitron, you get access to them, its a nightmare. I just put this into modem mode. Also note, it gets much worse if you have static IP. With statics, they get routed through a GRE tunnel.

Yep, I noticed it the other day, Ubuntu is pulling the latest postgresql 14 which seems to bring problems.

What is likely to be happening is your registration timers are too high and the NAT tunnels may be closing on the router. Try bringing your reg timers down to 120 seconds, that will usually fix it.

I think there is a SIP ALG on the Hitron routers, get that switched off.

The PDD should be the figure between the initial INVITE and either the 180 Ringing or 183 Session Progress. In the first case it was about 0.75 seconds in the second case it was much the same.

Post a sip trace of a call please

@Adrian Fretwell Nice. I was unaware that repo of mine was down, it was very old anyway.

Look in lua.conf.xml there are examples there

It should indeed be. I was in the middle of a job :)

liberty.chat #fusionpbx

I think I remember seeing a discussion about this recently in IRC, I think the problem resulted from an incomplete upgrade. Check the fusionpbx upgrade docs. I think some things may need deleting so that the new can be pulled.

But what was the technology? chan_sip or pjsip?

Try cid type to rpid or pid

Advanced settings in the Gateway, set Caller ID in From to true then stop and start the gateway.

For inbound calls. You will need to add your carriers IP to the ACL. Search on here , there are loads of examples

@MTR I agree completely with yours and @Adrian Fretwell comments. The problem is, we HAD that community. I have been involved with this project now for ten years. Up until about 2017 from about 2012, I do not think there was a single day when I did not post in the IRC channel and that included...

The guys at VitalPBX have offered me a couple of licenses to get a cluster going so we'll get something spun up and start putting it through its paces.

I've installed VitalPBX and am liking the look of it so far. I'm wondering if it is a serious contender to replace a FusionPBX cluster so I have contacted them to see if they will give me an evaluation for the carrier product. I'm liking the pricing and the feature set. It appears to have an...

It look like your carriers are not in your ACL.

I use solely Freeswitch to connect FusionPBX/trunks to Teams. I did have Kamailio too at first, then realised it is not needed. I also used Freeswitch at one time to send the options pings to MS but then found it more reliable to use SIPP for that instead.