parking lines/keys Cisco 8861 not working

[PJPMontreal]

It says "Invalid number" when pressed to take a call or when trying to park a call.
I used the following value for the key/line which is working fine on SPA504G but not on this one (neither on SPA525G):
fnc=blf+sd+cp;sub=park+*5901@my.domain;ext=park+*5901@my.domain;vid=1

 

[DigitalDaz]

Check if its the dialplan on the phone itself.

 

[PJPMontreal]

Thanks Daz,
this is the dialplan on the phone itself:
(*xxxxxxx|*xxxxxx|*xxxxx|*xxxx|*xxx|*xx*|*x|**xxxxx|**xxxx|**xxx|**xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.)

I checked and is exactly the same on both phones (SPA504G and Cisco 8861) but on the 8861 doesn't work when trying to place or unpark a call. Keep saying Invalid number...

 

[PJPMontreal]

BTW, can you help me with my other post:

Parking lines/keys Cisco SPA525G vs SPA504G via Provisioning!!!

Configuring parking slot in last 2 lines/keys Cisco SPA525G vs SPA504G via Provisioning. I'm having problem to setup the last 2 lines/Keys of the SPA525G via provisioning because I cannot change the lines/keys to "Disabled". Those lines keep saying Line "1" so the parking slots (5901 and 5902)...

www.pbxforums.com

 

[PJPMontreal]

Check if its the dialplan on the phone itself.

Please check my reply and let me know what you think..

 

[PJPMontreal]

Check if its the dialplan on the phone itself.

Hi, I found another post with the solution (for SPA525G) but I adapted the principle to CISCO 8861
Solution:

<Enable_IP_Dialing_1_ group="Ext_1/Dial_Plan">Yes</Enable_IP_Dialing_1_> (This is for SPA525)
<Enable_URI_Dialing_1_ ua="na">Yes</Enable_URI_Dialing_1_> (For CISCO 8861)

It's set to "No" in the default templates and "Yes" in the SPA50x templates. Basically the phone won't let you dial the "park+" part of the dial string without this enabled. It has to be done for every line # as well.

Please close the post as Solved