Installing FreeSwitch Modules on FusionPBX

[John]

Hello,

Does anyone know how to install freeswitch modules on a fusionpbx install?

I want to install mod_curl as an example

 

[DigitalDaz]

apt install freeswitch-mod-curl

Then edit /etc/freeswitch/autoload_configs/modules.conf.xml to load the module at startup.

 

[John]

Thank you! very much!

 

[smn]

apt install freeswitch-mod-curl

Then edit /etc/freeswitch/autoload_configs/modules.conf.xml to load the module at startup.

You can also do it in the GUI in Advanced > Modules.

 

[John]

You can also do it in the GUI in Advanced > Modules.

Thank you as well! After installing the module, I will do that.

 

[covici]

OK, so how do I install the module using the GUI? Right now I have an empty modules table in there -- this was the way it was installed.

 

[John]

OK, so how do I install the module using the GUI? Right now I have an empty modules table in there -- this was the way it was installed.

He didn't mean you can install on the GUI. He meant instead of editing /etc/freeswitch/autoload_configs/modules.conf.xm AFTER installation, you can update the record using GUI.

 

[covici]

Well, I was hoping to add all the modules, so others could check things and do some maintainence, but I discovered that the module category could not be changed from other -- is this expected behavior? I thought you should be able to choose endpoints or whatever it was supposed to be.