inbound DID not working

Status
Not open for further replies.

mundial3000

New Member
Jan 15, 2019
8
0
1
70
hi, Im new to fusionpbx, I install in digital ocean droplets, evrithing is working, outbound calls, extension to extension, but the DID , is not working, I see in the cli, say rejecting for ACL,but I put al IP adreses from the carrier in the allow domains, and send in the port 5080, and nothing happen, I read diferent post about that problem but nothing happen, can someone, tell me how to fix this? thankyou
 
hi, Im new to fusionpbx, I install in digital ocean droplets, evrithing is working, outbound calls, extension to extension, but the DID , is not working, I see in the cli, say rejecting for ACL,but I put al IP adreses from the carrier in the allow domains, and send in the port 5080, and nothing happen, I read diferent post about that problem but nothing happen, can someone, tell me how to fix this? thankyou


Where in the domains acl have you added the ip address's? As cidr ip with /32 or in domains without /32
 
I had the same issue before and a different post helped me resolve it. Mine was an ACL issue as well. I looked at my ACL list and my difference is that I do not have any IP in the domain section on the ACL list. Only in the CIDR area. Try editing the entries and removing the domain IP from them......If it works I do not fully understand why, just know that is how mine is setup. The why would be more of a question for Daz or someone more experienced then me haha.
 
No problem....Like I said I saw this in another post I am pretty sure that DigitalDaz had posted so credit goes to him on it. But glad it worked for you :)
 
Status
Not open for further replies.