How to configure UDP NAT

[vuthy09]

Can anyone know how to configure UDP NAT? help please?

 

[Adrian Fretwell]

If you mean "How do you make your endpoint NAT aware" You can configure STUN, ICE or TRUN, if you endpoint device supports one of those protocols.

 

[DigitalDaz]

Try enabling rport on your device if you have it.

 

[Adrian Fretwell]

Try enabling rport on your device if you have it.

Correct me if I'm wrong. rport helps in the correction of bad headers caused by NAT, but freeswitch will still report the endpoint as UDP-NAT. If the end point itself is aware of NAT and does not send any headers containing RFC1918 addresses then freeswitch will report the endpoint as UDP.

 

[DigitalDaz]

I'm unsure but I know asking for rport indicates that the device is behind NAT

 

[cagriaksu]

I'm unsure but I know asking for rport indicates that the device is behind NAT

And with some of our locations which are behind CGNAT even before the net reaches their modem, without rport turned on (yealink units) the phone can not even register to fusionpbx.