I was wondering if anyone has produced a guide to configure FusionPBX with ASTPP? My providers SIP trunks should be configured within ASTPP as I understand it with all the other configuration set up at the FusionPBX end. External calls would be sent from FusionPBX and would terminate after the call has been routed through ASTPP. Any guide or info would be great to help me understand.
- Status
In ASTPP You keep your clients with billing ( call charges and monthly fees for DID's ). SIP device from ASTPP You need to setup as a gateway in Your FusionPBX domain. Then just create a inbound and outbound rules.
I assume you mean routing all calls via ASTPP. How would I get billing for outgoing calls per domain (tennet) in ASTPP? Unless 1) they only use callerid of their DID or 2) I setup separate gateways for each tenant. Also, for incoming I will need to setup all did's in both, Fusionpbx & ASTPP ?
Hello,
I'm new in FusionPBX/Freeswitch and would like to integrate ASTPP for billing.
Does anyone had configured ASTPP as a gateway which could be the Trunk for FusionPBX?
ASTPP - Holds the VOIP Carriers and acts as a gateway Trunk (SIP/IP Auth/AIX2) and forward to the carrier to be log and billed.
FusionPBX - Act as a normal PBX (inbound and outbound would be routed over the SIP/IP/AIX2 if any for local trunking)
The design is attached below.
Kindly give me inputs and idea if this is doable.
Regards,
PogingBagsik
I'm new in FusionPBX/Freeswitch and would like to integrate ASTPP for billing.
Does anyone had configured ASTPP as a gateway which could be the Trunk for FusionPBX?
ASTPP - Holds the VOIP Carriers and acts as a gateway Trunk (SIP/IP Auth/AIX2) and forward to the carrier to be log and billed.
FusionPBX - Act as a normal PBX (inbound and outbound would be routed over the SIP/IP/AIX2 if any for local trunking)
The design is attached below.
Kindly give me inputs and idea if this is doable.
Regards,
PogingBagsik
Attachments
I use this scenario a lot. Works well.
I currently put opensips in front of astpp for load balance.
I currently put opensips in front of astpp for load balance.
Hi All,
Iam new to the forum. Please let me know if anyone got thsi solution working and if so can you please share with me please
Iam new to the forum. Please let me know if anyone got thsi solution working and if so can you please share with me please
I havew fews FreePBX and ASTPP working very fine with Fowardings DID@URL/IP, but with FusionPBX don'T work
thanks for sharing. I still think scalability fusionpbx with ASTPP will add more value. So as I understand you solution you have ASTPP with freepbx and ASTPP handles the inbound and outbound request from the VoIP provider?
For anyone doing prepaid, take a look at Ivozprovider https://github.com/irontec/ivozprovider it will give you much better protection from fraud than ASTPP.
anybody else tested IVOZ provider? I would actually prefer ASTPP with FusionPBX seems like a good solution to run but seems not alot of guys is running it this way in Production
- Status