FusionPBX calls not going through.

[ZakH]

Hi,

We installed a Fusion PBX as part of POC but have yet to make any successful calls.

We have a Telco Bridges ProSBC which uses IP auth for sip tunnels.
The tunnel shows 100% on the SBC side after following advice to setup the gateway with register=false but the status stays on stopped.
The only Codec we use is G729

I have successfully registered Microsip and Yealink phones to PBX, No calls are going out through even between extension.

Regards

 

[DigitalDaz]

Thanks for letting us know that.

If you actually want any help, post some logs

 

[ZakH]

Hi Daz,

Please find the log files attached.
I am getting an invalid gateway when trying to make calls.
The trunk is active a per our SBC
We have a the trunk setup via IP Auth

 

[DigitalDaz]

Is it IP authed? Is there a username and password in the gateway?

 

[DigitalDaz]

if its ip auth just put in dummyuser, dummypassword

 

[ZakH]

Hi Daz,

We have got the trunk working and saying registered.
We Can make Internal calls via G722 but not via G729

We have loaded the G729 codec (codec,G.729,mod_g729) calls is showing completed on the cdr but it has not been completed, the destination did not ring
Please find screesnhots shot and logs below.

 

[DigitalDaz]

mod_g729 as far as I am aware is a licensed product, have you installed the license?