FS PBX Now Installs in One Command – No More Separate FusionPBX Setup!

@vuthy09 I'm going to install a TLS certificate for a client tomorrow, and I will investigate if there are any issues. I'll keep you posted.
 
  • Like
Reactions: vuthy09
@vuthy09 I found no issues enabling TLS on the recent FS PBX install. However, it is not a simple procedure. It originates from how FusionPBX works behind the scenes. I'm going to streamline this in future releases of FS PBX.
Here is a few things you can check on your installation.
Run this command to make sure libssl-dev package is installed.
Code: 
dpkg -l | grep libssl-dev

You should see something similar to this.

1741997178380.png


Then follow this article to make sure you didn't miss any steps.
Enabling TLS Support for FS PBX (Using a Purchased SSL Certificate)
 
pbxgeek said:
@Jeff w How much RAM do you have on this server? You need at least 2 GB to compile without running out of resources.
Click to expand...
you are correct sir, i had it on an old Droplet 1v 1g, so i just upgraded it to 4vcpu 8g ram and wolah worked just fine, now im just going to put it back to something reasonable like 1v 2g
 
You must log in or register to reply here.
Top Bottom