customer sip trunks

Status
Not open for further replies.
M

mrjoli021

Member
Jul 20, 2017
133
2
18
47
Hello,

Does FusionPBX have a sip trunking option for clients? I am looking for a way to have clients connect to FusionPBX via our SBC's register using pilot number and then all DID's assigned to them will be sent to that registrations. Same thing as outbound calls, users can set the outbound callerID on their PBX assuming the number provided is one of their DID's.

I am setup on multi-tenants and it is working with hosted phones, but not sure how to set it up with sip trunking.
 
M

mrjoli021

Member
Jul 20, 2017
133
2
18
47
I come from a BroadSoft Background. In Broadsoft there is a way to create a SIP trunk to the customer and assign them a user/pass which in this case would be their pilot(main) number. We have an access SBC with domain sip.mysbc.com. From there Broadsoft routes the calls to the appropriate trunk. I am looking for something similar on FusionPBX. I have created a GW with the customers information on Fusionpbx. I have not added any extension or anything else. I am getting the error below on fs_cli. I have however added the user to LAN ACL and done a reloadxml
and reloadacl. Not sure if I need to add an extension with the user's DID or am I missing something?

----------------------------------------
in your directory and add a user with the id="3334445555" attribute
and you must configure your device to use the proper domain in its authentication credentials.
 
Status
Not open for further replies.
Top Bottom