gateway configuration

  1. T

    Bandwidth IP Based Gateway Setup

    I have looked through as many of the articles, even previous ones that referenced Bandwidth, and have followed the instructions, but I'm unable to get inbound calls, and outbound calls working. I'm mainly using Fusion PBX as a fax server, but was unable to get the normal PBX to operate as...
  2. G

    Gateway configured on Freeswitch and proxy as Kamailio

    I spent 2 days on this problem. Please leave any comment. Thanks in advance. Freeswitch's ip address is internal (behind NAT). I'm using a kamailio as proxy server (got Public IP). I registered gateway on freeswitch. When receive a call, SIP register, invite messages are 200 OK. But no RTP...
  3. V

    Inbound Calls not working with a new gateway

    Hi, I'm trying to add a new gateway to my fusionPBX. I have two working gateways and everything is nice with them. When I add this new gateway (it's from inopla), it's getting registered as expected and I can also use it to make outbound calls. Now, the issue is that when I create a...
  4. W

    How to setup a Sip Trunk

    Hi i’m new to FusionPBX, our sip trunk provider only give us the following parameters - Ip address and Port - Caller Id - No registration required as there are many fields in the gateway page, I don’t know in what fields should I put them? Any body can help me please.
  5. B

    FusionPBX Gateway without ACL

    Hi, Trying to set up a gateway to a asterisk box by having FusionPBX register to asterisk. The registration seems fine and shows registered on both ends. However, on an SIP invite from asterisk to fusionpBX, I get challenged for auth and FusionPBX xml_handler queries the PostgreSQL DB for...
  6. J

    Call recording with shared gateway

    Hi I have a fresh(ish) install of fusionPBX , version 5.1.0 with 6 or so domains on it currently. I have configured a gateway for our voice provider (Simwood in the UK) , which I have shared amongst all of the tenants by setting the domain to global. In the 'From Domain' I have tried using...
  7. katakefalos

    Setting the "from domain" on a Global gateway dynamic

    I would gladly pay someone $100 to find me the solution to this, either in the dial plan or perhaps the sip profile I have tried different dial plan settings like in "dialplan.png", I would like to have the setting please see "gateway.png" dynamic filled with the domain name used. If I set it in...
  8. Q

    Convert FreePBX outgoing trunk to FusionPBX Gateway.

    I have a Grandstream FXO configured as outgoing trunk: Device FXO port is registered with above user/password: Looking at Gateway settings I can't figure out how to duplicate this configuration. Please advise.
  9. G

    Adding custom parameters to gateway config

    Hello! I'm new to FusionPBX and Freeswitch and therefore searching solutions for some challenges :). My SIP provider needs mediasec to be able to encrypt rtp stream. Therefore I extended Freeswitch to speak mediasec (which primarily is part of the registration process). That's working fine. Now...